Search results for " Nanowires"

Core-shell Zn-doped TiO2-ZnO nanofibers fabricated via a combination of electrospinning and metal-organic chemical vapour deposition

2010

Zn-doped TiO2 nanofibers shelled with ZnO hierarchical nanoarchitectures have been fabricated combining electrospinning of TiO2 (anatase) nanofibers and metal-organic chemical vapor deposition (MOCVD) of ZnO. The proposed hybrid approach has proven suitable for tailoring both the morphology of the ZnO external shell as well as the crystal structure of the Zn-doped TiO2 core. It has been found that the Zn dopant is incorporated in calcined electrospun nanofibers without any evidence of ZnO aggregates. Effects of different Zn doping levels of Zn-doped TiO2 fibers have been scrutinized and morphological, structural, physico-chemical and optical properties evaluated before and after the hierarc…

Toward Tin-Based High-Capacity Anode for Lithium-Ion Battery

2014

Electrochemical deposition of SnCo alloys inside the nanometric pores of commercial membranes is described. Composition, morphology and crystallographic structure of the synthesized nanostructured alloys are reported as well as the results of electrochemical tests carried out both in half-cell and in full battery configuration to investigate the performance of these SnCo alloys as anodes for lithium-ion batteries. Optimized depositions yielded nanostructured alloys that performed 200 deep galvanostatic cycles at C/2 and 30 °C with 80 % capacity retention and coulombic efficiency higher than 97 % after 40 cycles Moreover, charge-discharge rate capability tests showed the high performance of …

Vertical standing copper nanowires for electrochemical sensor of nitrate in water

2020

Nitrogen, in the forms of nitrate (NO3-), nitrite, or ammonium, is a nutrient needed for plant growth and it is a common constituent of fertilizers [1]. When fertilizers are overused, they contaminate the ground water and then the food chain. For humans, a low level of nitrate is advisable because it increases the blood flow and has a good effect on both blood pressure and cardiovascular system. On the contrary, a high concentration of nitrate can be dangerous for humans. Nitrate ions undergoes different chemical transformations (i.e. to nitrite ions by Escherichia coli) producing different nitrogen-based compound such as nitrite ions, nitric oxide and ammonia [2]. These chemicals lead to s…

Struktūra un fotofizikālie procesi 0D un 1D InGaN kompozītu materiālos

2014

Šajā disertācijā tiek aprakstīti strukturālās un fotofizikālās MOCVD izaudzēto GaN nanovadu (NV) un InGaN kvantu punktu (KP) īpašības. Abos gadījumos ir parādīts, ka ex-situ RHEED mērījumi ir iespējami un sniedz kvalitatīvu informāciju par struktūru. Kombinācijā ar citām metodēm, pirmkārt, ir parādīts, ka nemetāliskā katalizatora veicinātā GaN NV īpašības, kad sintezēts uz GaN (0001) virsmas, atšķiras no tradicionāli iegūtajiem. Šinī gadījumā katalizators lokalizējas pie nanovadu pamatnes nevis tā galā un augšanas virziens ir atšķirīgs no kristalogrāfiskās c-ass, rezultātā iegūstot semipolārās NV struktūras. Otrkārt, InGaN kvantu punktos ir konstatēt saspiesta kristāliskā režģa struktūra au…

Influence Of The Electrical Parameters On The Fabrication Of Copper Nanowires Into Anodic Alumina Templates

2009

Abstract Metallic copper nanowires have been grown into the pores of alumina membranes by electrodeposition from an aqueous solution containing CuSO 4 . and H 3 BO 3 at pH 3. In order to study the influence of the electrical parameters on growth and structure of nanowires, different deposition potentials (both in the region where hydrogen evolution reaction is allowed or not) and voltage perturbation modes (constant potential or unipolar pulsed depositions) were applied. In all cases, pure polycrystalline Cu nanowires were fabricated into template pores, having lengths increasing with the total deposition time. These nanowires were self-standing, because they retain their vertical orientati…

Nickel-Indium Sulphide Core-Shell Nonostructures Obtained by Spray-ILGAR Deposition

2013

Ni nanowires (NWs) of different lengths were fabricated by pulsed potentiostatic deposition within pores of polycarbonate membranes. After template dissolution, substrates underwent sequential Spray-ILGAR® depositions of thin indium sulphide films. The effect of deposition temperature was also investigated. For low number of deposition cycles, results showed complete and uniform covering of metal over the entire length of NWs, with formation of Ni - In2S3 core-shell structures. However, with increasing number of deposition cycles films became uneven and crusty, especially at higher temperatures, owing to the simultaneous formation of nickel sulfide. This drawback was almost eliminated doubl…

Elemental distribution and structural characterization of GaN/InGaN core-shell single nanowires by Hard X-ray synchrotron nanoprobes

2019

Improvements in the spatial resolution of synchrotron-based X-ray probes have reached the nano-scale and they, nowadays, constitute a powerful platform for the study of semiconductor nanostructures and nanodevices that provides high sensitivity without destroying the material. Three complementary hard X-ray synchrotron techniques at the nanoscale have been applied to the study of individual nanowires (NWs) containing non-polar GaN/InGaN multi-quantum-wells. The trace elemental sensitivity of X-ray fluorescence allows one to determine the In concentration of the quantum wells and their inhomogeneities along the NW. It is also possible to rule out any contamination from the gold nanoparticle …

Sintesi per via elettrochimica di nanowires di leghe Co-Sn

2008

Anodic Alumina Membranes: From Electrochemical Growth to Use as Template for Fabrication of Nanostructured Electrodes

2022

The great success of anodic alumina membranes is due to their morphological features coupled to both thermal and chemical stability. The electrochemical fabrication allows accurate control of the porous structure: in fact, the membrane morphological characteristics (pore length, pore diameter and cell density) can be controlled by adjusting the anodizing parameters (bath, temperature, voltage and time). This article deals with both the fabrication and use of anodic alumina membranes. In particular, we will show the specific role of the addition of aluminum ions to phosphoric acid-based anodizing solution in modifying the morphology of anodic alumina membranes. Anodic alumina membranes were …

HYBRID WHITE LIGHT-EMITTING DIODES: STUDY AND FABRICATION OF THIN-FILM AND NANOWIRE-BASED DEVICES

I diodi ad emissione luminosa sono dei dispositivi a semiconduttore che posseggono straordinarie proprietà fisiche di generazione della luce. Il primo LED bianco si è mosso silenziosamente dalla metà degli anni 90 fino a un punto in cui, oggi, il mercato dell’illuminazione è stato totalmente rivoluzionato. A fronte dell’industria dell’illuminazione a stato solido che richiede LED sempre più luminosi ed economici, la ricerca scientifica risponde con strutture innovative, nuovi materiali più efficienti, anche combinati con l’uso delle nanotecnologie applicate. I diodi bianchi ibridi ad emissione luminosa, ad esempio, fanno anch’essi uso di un LED blu, come in un tradizionale diodo bianco, ma …